Interesting

Chemicals for Foam-Filled Tires

Chemicals for Foam-Filled Tires


We are searching data for your request:

Forums and discussions:
Manuals and reference books:
Data from registers:
Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

tire image by timur1970 from Fotolia.com

Certain foams can be used to fill tires. If the tire is punctured, nothing can escape, so the tire is just as useful as it was before. This type of filling is popular in vehicles that go over many terrains, such as golf carts, tractors and mowers.

Polyurethane

Most foam for tires is made of polyurethane. This is considered “ultra-lite.” This is considered helpful, as it does not add extra wear to the axle or engine. The heavier the tire is, the harder it is to turn. That can cause the engine to work harder, as well as the machine to go through more fuel on a regular basis. This type of foam can be put inside any type of tire via injection.

  • Certain foams can be used to fill tires.
  • This is considered helpful, as it does not add extra wear to the axle or engine.

Elastomeric

Another type of foam is elastomeric. This foaming process requires curing with a “tire carcass.” The carcass interior is placed under high atmospheric pressure. The foam is injected and stabilizes the unstable super-pressurized cells of the surface. The foam only fills halfway, as once the tire is depressurized, the foam will fill the rest of the space. Elastomeric foam is made up of mostly silicon.

Chemical Injection

The “foam” is made by injecting two chemicals into the tire that when combined, produce a solid foam strong enough for tires, but not much more in weight than air. One of the compounds is lightweight urethane. Different foaming products use different chemicals as the catalyst, but they are all hydroxyl in nature. This means they are a form of alcohol. By mixing this with the urethane, the product builds on itself, creating the “foam.” The byproduct of “foaming” is large amounts of carbon dioxide, so it should be done in well-ventilated areas.

  • Another type of foam is elastomeric.
  • The byproduct of “foaming” is large amounts of carbon dioxide, so it should be done in well-ventilated areas.


Watch the video: Roadside Flat Tire Fix On The Spot - I use whole can for small puncture (June 2022).


Comments:

  1. Arik

    It was an accidental case

  2. Macalpin

    If I were you, I would turn to search engines for help.

  3. Raedan

    I would like to encourage you to look for a site where many articles on the subject you are interested in.

  4. Beowulf

    Does it have an analogue?



Write a message